Follow

I import an image into Didger and calibrate it using a projection and points in lat/long. Once the image is imported, the coordinates on the screen are stuck at a certain value.

The coordinates on screen can get stuck at a certain value if the Calibration Units were not set to Lat/Long (dec deg) during calibration. Reimport the image, making sure to go to the Specify Coordinate System section, select the Specify option, and click on the Coordinate System button, and then set the Calibration Units in the Specify Coordinate System dialog box. Click OK to apply the change. 

 

Updated October 12, 2016

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

0 Comments

Please sign in to leave a comment.