Didger Installation Error: Error reading Setup Initialization File

The "Error reading Setup Initialization File" error is usually the result of an unsuccessful download. 

File sizes for the most updated versions of the full software download files are:

  • Didger 5.11: 93,189,440 bytes (88.8 MB)
  • Didger 4.4: 44,036,096 bytes (41.9 MB)
  • Didger 3.07: 14,816,496 bytes (14.1 MB)
  • Didger 2.05: 10,965,640 bytes (10.4 MB)
  • Didger 174: 3,323,499 bytes (3.16 MB)

Please right click over the EXE file you downloaded and go to Properties. Confirm that the Size of the file you have matches what it is supposed to be. If it is not, please try downloading the file again. Potential causes are AntiVirus or Firewall software blocking a piece of the download. If that is the case, you may have to turn down the security settings or download the EXE on a machine that has looser security.

Sometimes an installer package will have appeared to have downloaded successfully, because no error message was given about the download; however, you will not always receive an error message when the entire file was not downloaded successfully. When you run the exe file, it has enough information available to start running, but it will only get far enough to provide the error message shown above. Since it does not have the complete file content, it will not be able to read the setup initialization file.

If you still have questions, please contact


Updated: March 20, 2014

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request


Please sign in to leave a comment.