Follow

Why would I want to set the coordinate system for a map or layer in Surfer?

Not everyone needs to set or change the coordinate system for their map or layers in Surfer. However, there are a few scenarios where you would want to set the coordinate system for your map and layers. This doesn't necessarily have to apply only to those users with geographic data. You can still set the units of non-geographic data and convert them to other units (e.g. millimeters to centimeters).

 

Some scenarios where you would want to set or change the coordinate system for the layers or map include:

  • If your data sets are in different coordinate systems or units.

    In this case, you will want to set the coordinate system for each layer and the entire map so that the data overlays properly. For example: you have a base layer in UTM coordinates and want to overlay it with a contour layer created from a grid file in lat/long coordinates. The coordinate system for the base layer should be set to UTM, the coordinate system for the contour layer should be set to lat/long, and the map could be set to whatever system you want the map to be displayed in.

  • If you want to change the projection or units displayed by the map

    In this case, you will want to set the coordinate system for each map layer and the entire map. For example: you have a contour map created from a grid file in UTM coordinates and want to display the map with lat/long coordinates on the axes. The coordinate system for the contour layer should be set to UTM, and the coordinate system for the map should be set to lat/long.  Another example is if you have a grid file in inches and want to display the map in feet or meters.

  • If you want to export the map to a referenced file (i.e. KML, GeoTIFF, etc).

    In this case, the coordinate system of the map must be specified so that it can be exported correctly. If all the layers in the map are in the same coordinate system as the map, they do not have to be specified individually - just select Map in the Contents window, click the Coordinate System tab in the Properties window and click the Assign Now button. That will assign the same coordinate system of the map to all the unreferenced layers. 

 

Updated September 26, 2017

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

0 Comments

Please sign in to leave a comment.