In Strater I only see place holder logs and the logs don't show my data. What is wrong?

Strater will show all logs as generic place-holder logs when you are in Design Mode. The logs will show your data when you are in Active Mode. To check which mode you are in, either:
  • Click View | Display | View Properties. The View mode is shown in the Property Manager
  • Click on the Log tab in the ribbon bar. If the Design Mode command in the Display group is highlighted, you are in Design Mode


You can switch between Design Mode and Active Mode in the Property Manager or ribbon bar, or by pressing the F4 key on your keyboard.


Updated: April 30, 2018

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request


Please sign in to leave a comment.