• Click Log | Display | Overlay Logs. All logs for each borehole will be overlain (i.e. all logs for BH-1 will be overlain at location 1 and all logs for BH-2 will be overlain at location 2).
• Select both logs, in the ribbon click the Arrange tab and use the commands in the Align section.
• Select one log and note the X: and W: values in the Position and Size sections of the Arrange tab. Select the second log and enter the same values in the X: and W: boxes in the toolbar.
• Select one log and drag it on top of the other log.

In Strater 3 and 4, you can overlay two logs in the following ways:

• Go to Log | Overlay Logs. All logs for each borehole will be overlain (i.e. all logs for BH-1 will be overlain at location 1 and all logs for BH-2 will be overlain at location 2).
• Select both logs and use the commands under Arrange | Align Objects.
• Select one log and note the X: and W: values in the Position/Size toolbar. Select the second log and enter the same values in the X: and W: boxes in the toolbar.
• Select one log and drag it on top of the other log.

In Strater 1 and 2, you can overlay two logs in the following ways:

• Select both logs and use the commands under Arrange | Align Objects.
• Select one log. In the Base tab of the Property Manager, under Positioning note the Left, Right and Width values. Select the second log. In the Base tab of the Property Manager, under Positioning enter the same Left, Right and Width values.
• Select one log and drag it on top of the other log.

Updated May 3, 2018