Follow

I have imported well data into Voxler 4, how do I render the wells?

 

Rendering well data is a little different in Voxler 4 than it was in Voxler 3. After the welll data has been imported into Voxler 4 (see related articles below), a WellData module and a WellRender module need to be attached. Once these modules have been added, the wells should display in the Viewer Window. The typical network looks like this:

WellRender.jpg

 To add the WellData and WellRender modules:

  1. In the Network Manager, select the Collars table.
  2. Right-click and choose Well | WellData.
  3. In the Network Manager, drag the connector from the Trajectories table and connect it to the WellData module.
  4. In the Network Manager, drag the connector from the Samples table and connect it to the WellData module.
  5. In the Network Manager, select the WellData Module.
  6. Right-click and choose Graphics Output | WellRender.

 

Updated December 14, 2015.

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

0 Comments

Please sign in to leave a comment.