Follow

When I export a Voxler ScatterPlot to an Inventor IV file, why is the file blank?

 

The ScatterPlot module uses a custom Inventor "node" that isn't supported by the file format. Symbols are ignored when Inventor writes the file out. In Voxler 4, 3D DXF export is supported from the ScatterPlot module where the resulting DXF will contain the point data.

 

Updated November 30, 2015

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

0 Comments

Please sign in to leave a comment.